Go Back
315/24 Planetary Stranding Machine Cable Laying Equipment Back Twist For Super Thin Wire
Place of Origin: China
Model Number:315/24
Usage:Stranding
Max. Single-strander diameter:10mm
Warranty:1 Year
After-sales service:Online Support
Payment: 30%+70% T/T
Manufacturer: BEDYE
Stranding Cu, Al wire, ACSR and insulated wires
100% back-twist
steel-armoring or Cu-screening cables.
Model Number:315/24
Usage:Stranding
Max. Single-strander diameter:10mm
Warranty:1 Year
After-sales service:Online Support
Payment: 30%+70% T/T
Manufacturer: BEDYE
Stranding Cu, Al wire, ACSR and insulated wires
100% back-twist
steel-armoring or Cu-screening cables.
More Details
315/24 Planetary Stranding Machine Cable Laying Equipment Back Twist For Super Thin Wire
1. Application:
This machine is mainly used for winding a layer of less than 30 steel wires outside the circular plastic tube.
2. Main Character
- Back-twist method : planetary mechanism.
- The non-axle thimble twisting cage is equipped with mechanism friction tension control.
- The transmission shafts link all the machine parts together to keep stable stranding pitch, which can also be chosen frequency synchronization to control the machine.
- The machine is widely used, and manipulated conveniently with low-noise.
3. Main parameter of 315/24 planetary strander
- Single wire diameter: Ф0.3mm-Ф2.5mm
- Strand pitch range:43~766mm
- Cage max rotation speed: 37-89r/min
- capstan line speed range: 3.82~28.24 m/min
- Pay-off in cage: PN300 (attached drawing: PSJ300-14)
- Speed of flat steel tape winding machine:319r/min
- Thickness of flat steel strip × width:0.8x2.6mm
- flat steel tape winding machine pitch: 0 ~ 88.5mm (stepless electric control adjustment)
- flat steel tape winding machine motor power: 3.0kw (AC variable frequency motor)
- Take-up bobbin size: PN1250 (buyer standard)
- Center pay-off size: PN1300 (buyer standard)
- Main motor power:30Kw (AC variable frequency motor)
- Take-up motor power: 4.0Kw (AC variable frequency motor)
4. Main components of 24 bobbin planetary machine
- Ф1300 rotation pay-off stand
- # type guide line stand
- 24 bobbins strand cage
- Wire collecting die holder
- Positive side straightening device
- flat steel tape winding machine
- Electromechanical Meter counter
- Ф1000 double capstan device
- Ф1250 top tip take-up and arrange line frame
- Electrical control system
- Mechanical transmission system
- Safety cover
5. Electrical control system
- Electrical power cabinet and control cabinet shall be set and installed separately.
- Install the inching switch to facilitate equipment operation
- The operation panel is set with "efficiency table", that is, equipment running time.
- The equipment is started by one button, that is, the main engine and traction run, and the take-up is delayed compared with the start and stop of the main engine; The take-up starts before the host and stops after the host, and the start and stop delay time can be adjusted.
- After the power supply of the equipment is turned on, the lubrication system will enter the working state, reducing the probability of human operation errors.
- The voltage in the control circuit is AC220V.
- Cables and wires at all operating parts shall be protected.
- All wires shall be protected to prevent wire breakage.