Go Back
SJ-90MM RUBBER VULCANIZATION EXTRUSION LINE
Model NO.SJ90
Specification: 90mm
Origin: China
HS Code: 84778000
Voltage:380v, 3 phase and 5 wires
Delivery Time: 50 days
Warrant time: 1 years
Production Capacity:5 sets/Month
Transport Package:Wooden Package
Payment Terms: L/C, T/T
Specification: 90mm
Origin: China
HS Code: 84778000
Voltage:380v, 3 phase and 5 wires
Delivery Time: 50 days
Warrant time: 1 years
Production Capacity:5 sets/Month
Transport Package:Wooden Package
Payment Terms: L/C, T/T
More Details
SJ-90MM RUBBER VULCANIZATION EXTRUSION LINE
1.Application:
SJ-90 double layer co extruded rubber sleeve continuous vulcanization unit is a special machine for cold feeding rubber sleeve extrusion molding, suitable for the production of insulation sheaths for rubber cables such as natural, styrene butadiene, green butadiene, nitrile, ethylene propylene, chlorinated polyethylene, chlorosulfonated polyethylene, silicone rubber, etc. Can achieve single layer, double layer, and dual color lines (yellow/green)
2. Main parameter
- Diameter before extrusion Φ 1.0- Φ 16mm
- Diameter after extrusion Φ 4.0- Φ 20mm
- Heating form Steam
- Cooling form Water
- Tube length 60m (between upper and lower seals)
- Tube specification DN159 * 6 length of 40M, cooling tube 100 * 6 length of 20M
- Tube material Stainless steel seamless steel tube
- Tube production Inclined type
- Pay off rel size PN1000-PN2000
- Take up rel size PN1000-PN2000
- Upper belt wheel capstan Diameter of traction wheel Φ 1200mm: traction force 1200kg
- Lower belt caterpillar 2500kg
- Production line speed Not less than 60m/min
- Power supply Ground and neutral 3-phase 380V/220V ± 10% 50Hz ± 1Hz
- Compressed air 8Pa
3. Main components of Rubber sheathed cable continuous vulcanization production line
- PN2000 Shaftless pay-off stand
- Φ1200mm belt type wheel capstan
- Talcum powder box
- SJ-90/16 rubber extruder
- Φ50 single extrusion head
- Hydraulic upper seal
- Vulcanized tube
- Hydraulic lower seal (secondary seal)
- Water air balance control system
- Catenary controller
- Multi claw blow dryer
- 2500kg Belt Pneumatic caterpillar
- PN2000 Shaftless take-up with traverse stand
- Positioning wheel, steering wheel, limit roller
- Electrical control system
4.Electronic control system
- Power supply: three phase five wire system, 380 (± 10%), 50Hz
- The extruder host and traction motor are controlled by a sine frequency conversion speed control device,
- The electrical components inside the electric control cabinet are made by well known domestic enterprise Chint Electric
- The appearance and color of the electric control cabinet shall be configured according to the requirements of the purchaser
- The entire machine is controlled by Siemens PLC, with a 10.4-inch color touch screen canvas control human machine interface touch screen operation
- The main engine and traction machine are visually required with emergency stop buttons, and all emergency stop buttons are interlocked and linked.
